What should be paid attention to during the use of hard tooth surface gear reducer?
Publish Time: 2023-07-20 Origin: Site
The hard tooth surface gear reducer must be located under the flat propulsion base, and the anchor bolts must be driven and frozen.
Transmission - hardened surface reducer - each connecting shaft of the working machine, machine equipment must be precisely pointed to the center line
The main working limit of the shaft end and the output end of the reducer are manufactured according to h6.The internal threads of transmission components, such as couplings, pulleys and sprocket chains, must be manufactured in accordance with the corresponding public service restrictions to avoid installation.Too tight will destroy the rolling bearings, too loose a fit will jeopardize all normal drive transmission.
When the transmission parts such as sprocket chain and transmission gear are installed on the shaft, the rolling bearings should be as close as possible to reduce the bending stress of the shaft.When installing the motor on the hardened gear reducer, unsalted butter should be modified on the hole wall and keyway at the top of the worm to avoid over-tight installation and long-term rusting of the hole shaft.When ordering various hard tooth surface reducers, if the motor is slightly larger, you need suitable equipment.
Before the application, it is necessary to pay attention to the form and structure of the reducer, the industrial reference distance specification, the reduction ratio, the input shaft docking mode, the output shaft structure, the input shaft output shaft deflection and the direction of rotation, etc.
According to the standard requirements in 'Grease Selection and Application' in the sample, load the appropriate type of trademark pattern grease.After supplying the oil, tighten the top of the ventilator, pull out the small cone on the ventilator, and the hardened surface reducer is ready to work.Properly branded grease must be used and the proper amount of fuel must be handled.The oil must be replaced immediately according to the standard, especially after 150 hours of initial construction, great attention must be paid to replacing the new oil.
The water temperature for the hardened surface reducer is above 96°C.Under this temperature limit, only the water temperature does not rise, so you can use it with confidence.