What is the welding quality inspection method for NGW102-250 planetary reducer frame?

Publish Time: 2026-10-20     Origin: Site

1. Initial inspection of appearance quality

Visually inspect the welds with a 5~10x magnifying glass. There are no cracks, pores, undercuts, or unfusion defects. The welds are evenly formed and smooth. The excess height is controlled at ‌1~3mm‌, and there are no spatters or welding flash residues.

Use a sharp-nosed hammer to gently tap the periphery of the weld. If there is no noise or loosening or falling off of the solder joints, a preliminary inspection will be conducted to check for potential risks of incomplete welding on the surface.

2. Full-dimensional non-destructive testing

‌Magnetic Particle Testing (MT)‌: Clean the weld and the surrounding 50mm area to Sa2 level cleanliness, use the AC yoke method to magnetize longitudinally and transversely, and detect micro-cracks on the surface and near the surface. If the linear defect length is >2mm, it will be judged as unqualified. After the inspection, demagnetization is completed to avoid the residual magnetic field from affecting subsequent assembly.

‌Ultrasonic flaw detection (UT)‌: Use a 2.0~2.5MHz oblique probe, calibrate the sensitivity with a standard test block of the same material, and scan the entire weld to check for internal pores, slag inclusions, and unfusion defects. If there are no excessive defect waves and no abnormal attenuation of the bottom wave, it is qualified.

3. Mechanical property verification

‌Hardness test‌: Take 3 measuring points each at the center of the weld, the fusion line, the heat-affected zone, and the base metal area. The hardness of the heat-affected zone shall not exceed 120% of the base metal and be controlled at ‌≤280HV‌ to avoid the occurrence of a hard and brittle white layer that may cause subsequent cracking.

If necessary, penetrant testing can be supplemented, and minor surface defects in the blind areas of magnetic particle inspection can be rechecked twice, covering all welding areas.

4. Retesting of form and position tolerances

In a constant temperature environment of 20±1°C, use a three-dimensional coordinate measuring instrument to detect the key installation surfaces of the machine base:

The coaxiality of the bearing hole is ≤‌0.02mm‌, the flatness of the mounting reference surface is ≤0.03mm/m, and the overall deformation does not exceed ±0.05mm, ensuring the subsequent assembly accuracy of the planet carrier and internal ring gear.

5. Operation performance verification

No-load trial operation: Add the specified brand of lubricating oil, and run continuously in forward and reverse directions at rated speed for 2 to 4 hours. There is no abnormal impact or noise, and the vibration value of the machine base is ≤4.5mm/s.

Graded loading verification: Gradually load according to 25%→50%→75%→100% rated load. After 3 hours of full load operation, the oil temperature is ≤90℃, and there is no leakage or visible deformation in the weld area.

FEEDBACK

What are the common causes of failure of NGW102-6 planetary reducer bearing components?

What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?

How to judge whether there is a problem with the internal transmission pair of WP series reducer

What may be the causes of load fluctuations of WP series worm gear reducer?

Test the load before reducing the reducer Selection: on-site collection method of current, speed and load spectrum - Hangzhou Weigao Transmission