The size difference between K series bevel gear reducer from K37 to K187 is 1121mm!
Publish Time: 2024-03-08 Origin: Site
K series reducer is the only bevel gear series reducer among the four major series of reducers.The essential difference between it and other reducers is its internal gear structure.The gear structure inside is a bevel gear, and this bevel gear structure can only be used for vertical output.Therefore, its output mode is right-angle output, that is, the angle formed by the output shaft and the input shaft of the reducer is 90°.The K series reducer and the S series reducer are very similar in appearance. They are similar in appearance, but the internal structure is different. The inner structure of the S series reducer is that of a helical-turbine reducer.Only by taking apart the structures inside and comparing them can we better distinguish their essences.
There are basically 10 types of K series reducers. The reducers of this series are all foot-mounted.They are GK...foot-mounted helical bevel gear reducer, GKA...B foot hollow shaft-mounted helical gear reducer, GKV..B foot splined hollow shaft, GKH..B hollow foot Shaft locking disk installation, GKF is B5 flange installation, GKAF is B5 flange hollow shaft installation, GKVF is B5 flange splined hollow shaft, GKHF is B5 flange hollow shaft locking disk, GKA hollow shaft, GKV splined hollow Shaft, GKH hollow shaft locking disk, GKT hollow shaft torque arm installation, GKAZ is installed with B14 flange hollow shaft, GKVZ is installed with B14 flange splined hollow shaft, GKHZ is B14 flange hollow shaft locking disk.There are a lot of basic types, and the hollow shaft occupies the majority.This reducer can be combined with other reducers to form a bipolar reducer.The reduction ratio of the double-pole reducer can be very large and is used in some places with high work intensity.You can determine the type of hidden reducer according to your own needs.
The K series reducer has 6 installation directions like other reducers, ranging from M1 to M6. Like the two reducers introduced before, not all bevel gear reducers can meet these 6 installation directions. .All K series reducers can meet M1 installation, and are generally M1 installed by default.However, if you need to use the M2-M6 installation method, you need to meet two parallel conditions: the model is K77, K87, K97, K107 and the input speed of the connected gear reduction motor is greater than 2500 rpm; or the model is greater than K107 The input speed of the reducer is greater than 1500 rpm per package.In both cases, non-M1 installation can be used.Before purchasing, you need to clearly indicate the installation orientation you need to the relevant personnel, otherwise the product will be shipped to you in the default M1 installation orientation.
Regarding the size of the reducer, in your impression, K series reducers may be relatively large, but there are also small ones. The smallest model commonly used now is K37, whose length, width and height are 210mm, 220mm, and 100mm respectively.The largest commonly used model is the K187 reducer. The length, width and height are 946mm, 1341mm and 942mm respectively.
The above is the dimensional drawing of the K37 reducer, and the following is the dimensional drawing of the K187 reducer.The size difference between reducers of the same series and different sizes is quite large. The size data unit is MM (millimeters). If you need drawings of this size, you may wish to collect them.