The important reason why the reducer cannot start

There will be various problems during the operation of the reducer.Quickly solve problems based on professional knowledge, including the problem that the reducer cannot be started.The following editor will take you to learn how to quickly judge that the reducer cannot be started.
If the reducer cannot operate, first cut off the power supply of the reducer, check whether the circuit is smooth, check the rated voltage on the nameplate and check accordingly.Then check the gauge attached to the output shaft.If it cannot rotate, disassemble the reducer to determine whether it is a problem with the reducer.When checking, you need to pay attention to the state of the shaft and whether there is any abnormality.This is caused by moisture, cracked paint film protruding in some places can affect the operation of the shaft.It is caused by the decrease of insulator resistance and secondary drying.There is a burnt smell in the reducer.At this time, we only need to use a shovel to shovel off the excess paint film on the shaft and clean it.Then clean up any unevenness.These machines are simple to operate, but also pay attention.If not handled properly, new problems will arise.
One day, I turned on the power switch and found that the gear reducer was not working.Don't complain about the poor quality of the reducer.First cut off the power supply, check whether the power supply is normal, and check whether the voltage at that time is normal.If normal, check the target machine, that is, the meter connected to the output shaft.You can try to rotate the rotating shaft to see if it can rotate normally. If it cannot rotate, separate the gear reducer and try again, and then judge whether it is the problem of the reducer or the fault of the target instrument.
If it is a motor problem, the repair requires professional after-sales service.When testing a reducer, check in order of priority.Check for external causes first.It is easy to ignore the power supply problem of the reducer.After eliminating external problems, remove the reducer for maintenance.