Selection manual of DFY series hard tooth surface reducer

Publish Time: 2026-10-19     Origin: Site

1. Basic model and specification system

The DFY series is a four-stage hard tooth surface vertical shaft reducer, and the supporting hollow shaft output version is DFYK. The full series covers 14 standard center distance specifications:

DFY160, DFY180, DFY200, DFY225, DFY250, DFY280, DFY320, DFY360, DFY400, DFY450, DFY500, DFY560, DFY630, DFY710. The larger the center distance, the stronger the mechanical load-bearing capacity.

2. Core Selection parameter table

3. Model naming rules

Standard model format example: DFY 560 - 200 - III JB/T9002-1999

DFY: four-stage hard tooth surface conical cylindrical gear reducer

560: Final stage center distance (mm)

200: Nominal transmission ratio

III: The third assembly type

JB/T9002-1999: Implement national standard number

4. Selection Core verification steps

1‌. Mechanical torque priority‌: First calculate the actual output torque based on the equipment load, and multiply it by the usage coefficient of the corresponding working condition (1.5~2.0 for strong impact working conditions such as bucket lifts and scrapers) to ensure that the allowable mechanical torque of the sample is not exceeded.

2‌. A must-do thermal power check‌: DFY is a four-stage transmission with many gear pairs and high heat generation. Under 24-hour continuous operation, even if the mechanical torque reaches the standard, the thermal power must be checked. When the ambient temperature is high and ventilation is poor, it must be upgraded to forced circulation oil lubrication + cooler to avoid excessive oil temperature causing tooth surface gluing.

3. Supplementary check of shaft load: When the output shaft is connected with a sprocket and the drum cantilever, the allowable radial force and axial force must be checked to avoid shaft deflection causing eccentric wear of gear mesh; when equipped with a backstop, it is necessary to confirm that the axial thrust does not exceed the allowable load of the bearing.

‌4. Assembly and rotation confirmation‌: There are four assembly types: I/II/III/IV. The output shaft rotation can be clockwise (S), counterclockwise (N) or bidirectional (T), which must completely match the on-site installation space and equipment rotation.

5. Standard lubrication and cooling configuration

The default oil pool splash lubrication + natural cooling under normal working conditions makes maintenance simple;

With large center distance and 24-hour continuous heavy-load operation, forced circulation lubrication interfaces need to be reserved in the Selection stage to avoid later modifications.

6. Typical adaptation scenarios

It is specially designed for conveying and lifting equipment such as bucket elevators, low-speed scraper conveyors, large-angle long-distance belt conveyors, etc. It can also cover large-speed ratio and heavy-load general transmission mechanisms in metallurgy, mining, building materials, cement and other industries.

FEEDBACK

What are the maintenance points for ZDY250-3.55-II hard tooth surface reducer in food plants?

How to perform daily inspection of the sealing system of ZDY315-4.5-I hardened reducer?

What is the clearance standard of P series planetary reducer under different working conditions?

How to choose the P series planetary reducer suitable for your equipment

How to detect early fracture of ZLYJ173 reducer gear