Reducer manufacturers teach you how to install the reducer correctly

When many people use the reducer, the output shaft of the reducer is often broken due to human factors such as illegal installation, which causes the company to suffer a lot of unnecessary losses.So, how to install the gear reducer correctly? The gear reducer manufacturer Huide Nuo will introduce in detail how to install the gear reducer correctly.

In the reducer series, the gear reducer is used in gear, stepping, DC and other transmission systems because of its small size, wide deceleration range and high precision.Its function is mainly used to reduce the speed, increase the torque, and reduce the rotational inertia ratio of the load/motor under precision transmission.The correct installation and use of the reducer is an important part of ensuring the normal operation of mechanical equipment.Therefore, when installing the gear reducer, please be sure to carefully assemble and use it in strict accordance with the following installation and use related matters.

1. Before installation, confirm whether the motor and the reducer are in good condition, and strictly check whether the size of the connection between the motor and the reducer matches. Here are the dimensions and matching tolerances of the motor positioning boss, input shaft and reducer groove;

2.Rotate the screw on the dust-proof hole outside the flange of the reducer, adjust the PCS system clamping ring so that the side hole is aligned with the dust-proof hole, insert the inner hexagon and tighten.Then, remove the motor shaft key;

3. Connect the motor with the reducer naturally.When connecting, the output shaft of the reducer must be consistent with the input shaft of the motor, and the two outer flanges must be parallel.If the concentricity is inconsistent, it will cause the motor shaft to break or the reducer gear to wear.In addition, during the installation process, hammering is strictly prohibited to prevent axial force or radial force from damaging bearings or gears.Be sure to tighten the installed bolts before tightening them.Before installation, wipe the anti-rust oil on the motor input shaft, positioning boss and reducer connection with gasoline or zinc sodium water.Its purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear and tear.