Precautions for gear unit disassembly

Publish Time: 2021-11-19     Origin: WGT

Reducers are used in many machinery industries.It is an integral part of mechanical operation.We usually have to pay attention to the maintenance of the reducer.We clean the reducer during maintenance.However, many people only clean the outside.In fact, the cleaning of the internal parts of the reducer can not be ignored.Most people only clean the outside of the reducer. If the inside is not cleaned, the operation of the machine will be affected, so the parts must be cleaned.
When cleaning the reducer, be sure to disassemble it carefully so as not to affect the parts of the reducer and affect the reducer.All cleaning machines on the market disassemble the reducer for cleaning.Is there a product that can be cleaned without disassembling the washing machine?The reducer manufacturer will introduce disassembly precautions for you.
Remove the upper casing of the reducer.If the reducer has a half-coupling, please take out the half-coupling first.Remove the retaining bolts, thread the nuts onto the bolts so they hold properly, and inspect the upper shell for defects and cracks.Mark the assembly mark and remove the bearing end shield.First check for missing bolts and other abnormalities.After confirmation, lift the upper case with the clip screws, lift it up and place it on the prepared bottom plate.Measure the clearance of each bearing with a galvanometer or lead pressing method.Measure further points for each set of bearings and record them.Drain the lubricating oil in the reducer and store it in a special oil drum.Lift the drive shaft and driven shaft assembly.Mark gear meshing.After lifting, each gear assembly should be placed on a dry wooden board, neatly and stably arranged to prevent collisions, and each bearing and gear should be removed.Clean bearings, cases and gears with kerosene in preparation for subsequent inspection.

FEEDBACK

How to distinguish between gear tooth surface gluing and pitting corrosion: key points of identification and preventive measures - Hangzhou Weigao Transmission

Gearbox Vibration Causes: What a 2x Running Speed Peak Really Means

How to measure reducer gear wear: tooth thickness, common normal and scrap criteria - Hangzhou Weigao Transmission

Gearbox Coupling Alignment on Site: Laser Steps and Acceptance Limits

How to determine the gear modification of hard-tooth surface reducer: tooth top modification, tooth drum shape and K-shaped diagram - Hangzhou Weigao Transmission