Lubrication and function of cycloid reducer
Publish Time: 2021-10-14 Origin: 威高传动
The lubrication of the reducer is a very important part of it.Whether it is a planetary reducer, a gear reducer or a worm gear reducer, it is inseparable from the lubrication of the maintenance reducer.The transmission of the cycloid reducer generally adopts regular lubrication, and the lubricant of the reducer can be lubricating oil or grease.Different reducers have different lubrication conditions, and different cycloid reducers are also different.
When the peripheral speed of the cycloid reducer is greater than 12m/s, oil injection lubrication should be used.When it is greater than or equal to 25m/s, the nozzle can be located on the meshing edge or exhalation edge of the gear teeth; when it exceeds 25 meters per second, the nozzle should be located on one side of the gear teeth, so as to cool in time and lubricate the gear teeth at the same time.Generally, the lubrication method of closed gear reducer is determined according to the peripheral speed of the gear.When the peripheral speed of the gear is less than 12 meters per second, the large gear is immersed in oil for lubrication.When the gear is working, it can evenly bring the lubricating oil to the tooth surface, and throw the oil to the box wall for heat dissipation.The depth to which the gear is immersed in the oil can be determined by the peripheral speed of the gear.Cylindrical gears are usually smaller than the tooth height, but generally should be greater than 10mm; bevel gears should be immersed in the full tooth width, at least half of the tooth width.
The amount of oil in the sump depends on the power transmitted by the gears.For single-stage transmission, 0.35-0.7lo oil is required for every kilowatt of power transmitted.For multi-stage transmissions, oil requirements are multiplied in stages.