How to prevent the reducer from rusting

The controller pin reducer is a new type of transmission device, which is applicable to the principle of planetary transmission and adopts maintenance pin tooth meshing.All transmissions of the cycloid speed reducer can be divided into three parts: input part, reduction part and output part.Reducer is a self-contained component consisting of gear transmission, worm drive and gear worm transmission, enclosed in a rigid housing.It is usually used as a reducer between the prime mover and the working machine.Generally speaking, the rust of the reducer is caused by the presence of oxygen and moisture in the lubricating oil, and the so-called corrosion condition is caused by the acidic components and sulfide substances in the reducer oil. In this way, some anti-corrosion Rust can add components to the oil of the reducer to complete the maintenance of the reducer.The anti-rust layer of the reducer is a volatile combustible gas.Do not fire while the sight glass cover is open.The output and input shaft ends are respectively coated with anti-rust coating.Reducers must be stored in an overridden place.It needs protection from rain, sun, frost and moisture.It cannot be exposed to the open air.Otherwise, it is easy to produce condensate in the reducer and cause the reducer to rust.Use this method as hot-dip coating or electroplating to add an oxide film or protective layer on the outside of the reducer to prevent rust caused by water and gas of the reducer unit, including these substances.