How to judge by the sound that the B3SH16-31.5 gearbox is about to be damaged. Summary of typical abnormal noises
Publish Time: 2026-10-22 Origin: Site
1. High-frequency sharp whistling sound
Sound characteristics: A high-frequency harsh squeal that increases synchronously with the increase in speed. It is especially obvious at the moment when the speed suddenly rises. The squeal will be further intensified when the load increases.
Fault direction: The gear backlash is abnormally small and the bearing preload force is improperly adjusted. This is an early warning that the tooth surface is about to be glued and the bearing clearance is out of control.
2. Low continuous roaring sound
Sound characteristics: Continuous low-frequency dull "buzzing" sound, the overall listening feeling is thick and dull, accompanied by an obvious sense of vibration conduction of the shell.
Fault direction: The bearing clearance is too large, and the rolling elements and raceways have early fatigue spalling, indicating that the internal matching accuracy of the bearing has failed and is about to enter the rapid wear stage.
3. Fine rustling and rubbing sound
Sound characteristics: A uniform and continuous fine "rustling" sound, which becomes louder as the load increases, without any obvious impact.
Fault direction: Early pitting corrosion and abrasive wear have occurred on the tooth surface, the oil film has begun to break, and dry friction directly occurs on the metal surface, which is the initial signal of the peeling off of the hardened layer on the tooth surface.
4. Periodic clicking sound
Sound characteristics: intermittent "click" impact sounds that are strictly synchronized with the gear frequency. The impact is strongest at the moment of starting and stopping. In severe cases, it is accompanied by obvious shaking of the cabinet.
Fault direction: Local chipping or early micro-cracks on the tooth surface, or the tooth gap seriously exceeds the standard, which is the most typical early warning sound before a broken tooth failure occurs.
5. Empty and irregular clanging sound
Sound characteristics: The open impact sound is particularly obvious when the load is low and no-load. The abnormal sound is weakened when the load is increased, and the sound has no fixed and strict period.
Fault direction: The gear backlash exceeds the standard and the shaft system moves axially, indicating that the assembly reference has failed, and long-term operation will cause unbalanced wear of the entire tooth surface.
Under normal working conditions, the sound of the B3SH gearbox is a smooth and even brisk meshing sound, and the noise at a distance of 1 meter from the box does not exceed 85dB(A). Once any of the above types of abnormal noise occurs, it is necessary to immediately reduce the load and investigate to avoid minor faults turning into irreversible gearbox scrapping accidents.