How to deal with the surface damage of the planetary gear reducer?

Publish Time: 2021-11-25     Origin: WGT

The planetary reducer has 6 large gear contact surfaces, and the load is 360 degrees.Multiple tooth surfaces receive instantaneous shock loads evenly, high torsional impacts can be accepted, and main bearing components will not be damaged or destroyed due to high loads.
The gears of the planetary reducer are small in size and light in weight.In the planning of traditional gear reducer design, multiple sets of large and fine gears are shifted alternately to drive the system to reduce the speed, because the reduction ratio is twice that of two different gears, the size of the gears is the meshing relationship, and they must be There is a certain interval, so the gearbox contains a large space, especially when the combination of high-speed ratio needs to be combined by two or more reduction gearboxes below, the required relative capacity structural material is weakened, and the length of the teeth can be extended , resulting in some huge volumes and parts.
At present, planetary gear reducers have been widely used.It should be noted that the surface of the planetary gear reducer is easily damaged during operation.What should we do now?
1. The bearing is severely worn, overloaded or impacted, causing the bearing of the planetary gear reducer to be deformed or slightly bent, which will cause the rotor to sweep the inner hole.The result of scanning the chamber is that the surface of the core is scratched, the core is unwrapped, and the winding shell burns.
2. Due to frictional overheating, the silicon steel plate in the worn part of the worn part is annealed, resulting in a decrease in the permeability of the silicon steel plate.If it is not dealt with in time, the eddy current will increase with the aging of the iron core of the planetary gear reducer, resulting in an increase in the temperature rise of the planetary gear reducer, resulting in overheating or even burning the micro-motor.
3. When the winding insulation passes through the short circuit or burns the surface of the iron core in an arc, it is usually uneven, which will not only affect the normal operation of the planetary gear reducer, but also cause a short circuit between the silicon steel plates and increase the eddy current of the iron core.

FEEDBACK

What are the common causes of failure of NGW102-6 planetary reducer bearing components?

What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?

How to judge whether there is a problem with the internal transmission pair of WP series reducer

What may be the causes of load fluctuations of WP series worm gear reducer?

Test the load before reducing the reducer Selection: on-site collection method of current, speed and load spectrum - Hangzhou Weigao Transmission