How to deal with the noise of planetary reducer

Publish Time: 2021-10-21     Origin: 威戈传播

The reducer is used in many equipments, which greatly improves people's work efficiency.The planetary reducer also has a high utilization rate, and the effect is to give people a thumbs up.However, sometimes there is noise during planetary deceleration, which will affect people's normal work, and the damage to the ears in this working environment will last for a long time.What should be done when there is noise in the planetary reducer?
The noise of the planetary reducer is mainly due to friction, feeling and collision with the transmission gear.How to effectively reduce and reduce noise makes the mixer more in line with the environmental protection requirements of key research topics at home and abroad.Correction minimizes the method used to generate dynamic load and velocity jitter, then reduces noise.This proves to be more useful in practice.
Proper equipment is an important part of using and maintaining a planetary reducer.This is to ensure the normal operation of the mechanical equipment, the installation speed and the installation speed ratio are within the proportional range, and the planning method, so as to reduce or avoid the influence of the gear meshing pitch circle, and reduce the obvious planetary noise reducer.
Equipment operation relationship, the main shaft of the planetary reducer avoids deformation and rated force.Planetary gear bearings, the planetary deceleration distance between the machine and the operation should be as small as possible without affecting normal operating conditions, which is 5-10mm.
The packaging of the planetary gear unit coupled with the planetary reducer works directly on the main shaft of the working machine.When it is located on the chassis of the anti-torque planetary gear body and mounted on the chassis or body, the planetary reducer operates other balancing methods.The bag making machine is directly matched, and the other end is related to the support of the belt device.
Anti-torque bracket installation: The anti-torque bracket should be installed toward the operating machine to reduce the rated shaft torque of the operating machine.On one side of the planetary gear, the anti-torque support should be a sleeve of the solid coupling end of the bearing rubber or other elastomers to avoid bending and absorb torsional vibrations.

FEEDBACK

What are the common causes of failure of NGW102-6 planetary reducer bearing components?

What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?

How to judge whether there is a problem with the internal transmission pair of WP series reducer

What may be the causes of load fluctuations of WP series worm gear reducer?

Test the load before reducing the reducer Selection: on-site collection method of current, speed and load spectrum - Hangzhou Weigao Transmission