How do planetary reducer manufacturers solve the problem of water immersion

The application range of planetary reducer is more and more extensive, and it is used in various automatic mechanical equipment, so its working environment is also different.For example: the planetary reducer used by the manipulator, some of its working environments are high-frequency repeated operations, some of which are intensive impact operations; bumpy and vibration operating environments, etc.Planetary reducers are used in different environments, and various glitches may occur due to certain reasons or accidents.Among them is the flooding failure of the planetary reducer, and the operation has stopped. What should I do?The following planetary reducer manufacturers will provide you with quick solutions to make the planetary reducer work again.

1. First of all, the planetary reducer manufacturer should observe the external conditions, first do cleaning work, and wipe off the sludge and impurities on the surface of the servo planetary reducer.What needs to be paid attention to during the process is to handle it with care, do not damage the surface of the planetary reducer, let alone rotate the motor shaft.Because at the moment we don't know what the internal failure is.

2. Next, the body of the planetary reducer can be disassembled, and the sludge and water stains on the inner cavity of the housing, the bearing of the sun gear, the arm frame, the oil seal, the rotor and the slip ring can be cleaned, and the windings can be checked for desoldering. Whether it is corroded and stuck in the brush holder, whether the pressure of the brush is normal, whether the surface of the brush and the slip ring is tightly attached, find the fault in time, and quickly eliminate it.

3. After troubleshooting, the planetary reducer manufacturer simply maintains against wet water.To dry the winding, it can be baked with an incandescent lamp to evaporate the water, and it can also be placed in a ventilated place to dry naturally (this method takes a relatively long time).But do not use electric current heating or baking with open flame to prevent short circuit or damage the insulation layer.After drying, it is necessary to check the insulation performance of each winding coil with a megohmmeter or a multimeter.If it is found that there is a place with poor insulation, it can be repaired at the motor maintenance department.

4. Reassemble the body of the precision planetary reducer and conduct a trial run.If there is no problem in the test run, you can continue to use it.