Geared Motor Troubleshooting
Publish Time: 2021-11-30 Origin: WGT
Whether it is a geared motor or a geared motor, its faults usually have many different classifications.For example, unstable voltage, improperly installed capacitors, faulty starter components, damaged gears, shaft centers and bearings, broken connecting wires, poor fixation, etc., but their performance is generally divided into nine categories.The following is a summary of various geared motor failures:
1: Under no-load condition, the motor does not rotate.
Causes are: improper voltage; incorrect or unconnected capacitors; poor action of single-phase motor starters; damage to gears, shafts and bearings;
2: The motor does not rotate under load.
The fault may be caused by the motor or a motor running under overload, or the gear may be damaged;
3: abnormal fever
The possible reasons for this failure are: overload operation; high or low voltage, bearing wear, etc.;
4: Too much noise
The cause of this failure is usually damage and gear wear;
5: Abnormally unstable running noise;
The reasons are: the gear bearing is seriously worn or the motor is not well fixed, and the flange screws are loose;
6: Too much vibration
When there is too much vibration, of course, you need to check that the mounting screws on the feet or flanges are secure.Other possible reasons are: lack of oil, oil pollution, etc.;
7: Brake failure
The reasons for this kind of failure usually include: the gap is too large or too small, usually called brake failure;
8: Oil leakage
Oil spills often lead to rapid consumption of oil in equipment, leading to heating, gear damage and a host of problems;
9: The coil is damaged.
The cause of the problem is usually complex, it could be a voltage problem or a current problem.Also, coil damage can also occur when the capacitor is not installed or water gets in.
1: Under no-load condition, the motor does not rotate.
Causes are: improper voltage; incorrect or unconnected capacitors; poor action of single-phase motor starters; damage to gears, shafts and bearings;
2: The motor does not rotate under load.
The fault may be caused by the motor or a motor running under overload, or the gear may be damaged;
3: abnormal fever
The possible reasons for this failure are: overload operation; high or low voltage, bearing wear, etc.;
4: Too much noise
The cause of this failure is usually damage and gear wear;
5: Abnormally unstable running noise;
The reasons are: the gear bearing is seriously worn or the motor is not well fixed, and the flange screws are loose;
6: Too much vibration
When there is too much vibration, of course, you need to check that the mounting screws on the feet or flanges are secure.Other possible reasons are: lack of oil, oil pollution, etc.;
7: Brake failure
The reasons for this kind of failure usually include: the gap is too large or too small, usually called brake failure;
8: Oil leakage
Oil spills often lead to rapid consumption of oil in equipment, leading to heating, gear damage and a host of problems;
9: The coil is damaged.
The cause of the problem is usually complex, it could be a voltage problem or a current problem.Also, coil damage can also occur when the capacitor is not installed or water gets in.