Description and solution of broken shaft of reducer

Publish Time: 2021-09-24     Origin: 威高传动

Sometimes the shaft of the reducer may be broken.Why does the output shaft of the reducer drive motor break?In order to solve this problem, the cross-section of the output shaft of the drive motor unit of the reducer was checked, and it can be seen that the cross-section of the output shaft is the same as that of the reducer.
This can simply explain that the main factor that causes the drive motor of the reducer to break the shaft is the difference in concentricity between the motor and the reducer device during operation.
If the concentricity loss deviation is large, the radial force will increase the shaft temperature difference transmitted by the motor and damage the metal structure.After all, the radial force will exceed the radial force that the output shaft of the motor can bear, and will eventually damage the output shaft of the drive motor.
When the concentricity of the motor device and the reducer device is perfect, the energy received by the motor drive is the ability to roll, and the lubricity is better during operation.But in the case of non-concentricity, the output shaft should bear the radial force from the input end of the reducer.The long-term effect of this radial force will force the output shaft of the motor to bend, and the bending direction will constantly change as the output shaft rolls.Once the output shaft rolls, the direction of the lateral force changes.
In short, if the motor device is concentric with the input position of the reducer, that is, the reducer and the motor run closely and are in close contact. If the device is not concentric, there will be a gap between the contact surfaces.between them.
The larger the concentricity fault, the shorter the time for the drive motor output shaft to break.When the output shaft of the driving motor is broken, the input end of the reducer will also bear the radial force from the motor.Assuming that the radial force exceeds the maximum radial load they jointly bear, its action will also cause the input end of the reducer to deform or even crack.Therefore, ensuring concentricity is the main way to prevent broken shafts.
The above is the explanation of the reasons for the non-concentricity of the reducer and the high probability of broken shaft, and the related solutions.

FEEDBACK

What are the common causes of failure of NGW102-6 planetary reducer bearing components?

What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?

How to judge whether there is a problem with the internal transmission pair of WP series reducer

What may be the causes of load fluctuations of WP series worm gear reducer?

Test the load before reducing the reducer Selection: on-site collection method of current, speed and load spectrum - Hangzhou Weigao Transmission