Daily Maintenance and Installation Procedures for Right Angle Reducers

Publish Time: 2021-11-30     Origin: WGT

Daily Maintenance and Installation Procedures for Right Angle Reducers
Every machinery commodity is its own key component.In daily maintenance, many right angle reducer components are also very important.It can be said that the key components of the right-angle reducer are surfaces and a part of household appliances.How should the part be cleaned and maintained?
1. Maintain the surface of the spare parts of the right angle reducer: clean the outer surface of the NC lathe and each plug cover, and keep the inside and outside clean without rust and oil.Clean three bars.Check and replenish every screw, rocker ball and rocker.After cleaning, all parts should be wetted as needed.
2. Maintenance of right-angle reducer components and household appliances: clean the dust on the right-angle reducer electrical equipment box.Electrical equipment is fixed and tidy.Of course, in routine maintenance, not only these aspects need to be maintained.It's just cleaning and maintenance of many critical components.Other components such as right angle reducers and reducers also need to be maintained.
The first step is to determine whether it is intact before installation, and strictly check whether the specifications of the various components between the motor and the right-angle reducer match.This is the precise positioning punch of the motor.Type the specification and matching tolerances for the shaft and groove of the right-angle reducer.
The second step is to unscrew the screw on the anti-fouling hole on the flange plate side of the right-angle reducer, adjust the PCS system clamping ring, align its side hole with the two ends of the anti-fouling hole, insert it into the hexagonal socket, Tighten it, and remove the motor shaft key.
The third step is to naturally connect the motor with the right angle reducer.When connecting, ensure that the coaxiality of the output shaft of the right-angle reducer is consistent with the input shaft of the motor, and the flanges on both sides are connected in parallel.If the shaft degrees are inconsistent, the motor shaft will be damaged, or the transmission gear of the right-angle reducer will be damaged.In addition, it is forbidden to hit with a steel hammer during assembly to avoid damage to rolling bearings or transmission gears due to excessive axial force or axial force.Be sure to tighten the mounting bolts before tightening them securely.Before installation, key the motor into the shaft, accurately position the punch and anti-rust agent on the connecting part of the right-angle reducer, and clean it with gasoline or sodium water.Its importance is to ensure the accessibility of the connection and the coordination of the operation, and to avoid unnecessary damage.
Before the motor is connected with the right-angle reducer, please make the motor shaft groove and the vertical force distance bolt.To ensure even bearing force, tighten the mounting bolts randomly, but do not tighten them, then tighten the other two mounting bolts at the top corners, and finally tighten the four mounting bolts.Finally, tighten the bolts securely.According to the marked fixed torque data information, all torque bolts of the right-angle reducer should be stabilized and checked, and checked with a torque wrench.

FEEDBACK

What are the maintenance points for ZDY250-3.55-II hard tooth surface reducer in food plants?

How to perform daily inspection of the sealing system of ZDY315-4.5-I hardened reducer?

What is the clearance standard of P series planetary reducer under different working conditions?

How to choose the P series planetary reducer suitable for your equipment

How to detect early fracture of ZLYJ173 reducer gear