Cycloidal pin gear reducer - application of planetary rotation

Publish Time: 2021-10-12     Origin: 威高传动

Cycloidal pin gear reducer is a new type of transmission device that applies the principle of planetary transmission and adopts cycloidal pin gear teeth meshing.All transmissions of the cycloid reducer can be divided into three parts: input part, deceleration part and output part.The input shaft is equipped with a double eccentric sleeve offset by 180°, and the eccentric sleeve has two roller bearings called rotating arms, which constitute the H mechanism.The center holes of the two cycloidal wheels are the raceways of the rotating arm bearing on the eccentric sleeve. The cycloidal wheels mesh with a set of circular needle teeth on the needle roller gear to form a tooth difference. Ratio of the reducer, the pin gear is equipped with a pin gear)
When the input shaft rotates one cycle with the eccentric sleeve, due to the characteristics of the cycloid gear profile curve and its limitation by the needle teeth on the pin wheel, the motion of the cycloid gear becomes a plane motion rotation and rotation.When the input shaft rotates one circle forward, the eccentric sleeve also rotates one circle, and the cycloid gear rotates one tooth in the opposite direction to obtain deceleration. Then, with the help of the W output mechanism, the low-speed rotational motion is transmitted to the output shaft through the pin shaft, thereby obtaining a higher speed. low output speed.


The purpose of this utility model is to provide a planetary cycloid reducer, including a vertical base, a motor is housed in the vertical base, an input shaft, an output shaft coaxial with the input shaft, and the input shaft rotates through the shaft.Motor linkage device, the input shaft is covered with eccentric bearings, the pin gear housing is installed on the stand, the pin gear pin sleeve and the pin gear pin are installed on the inner circumference of the pin gear housing, and several pin shafts are evenly distributed on the outer circumference of the input shaft. The shaft is equipped with two cycloidal wheels meshing with pin-toothed pins, and a spacer is installed between the cycloidal wheels. On the corresponding eccentric part, one end of the output shaft is equipped with a mounting plate for the cycloidal wheel, and the end of the mounting plate facing the cycloidal wheel is evenly distributed with several mounting holes along the circumference, and the pin shaft is inserted into the corresponding mounting hole. On the type base, a distance ring is arranged between one end of the eccentric bearing and the bearing.


FEEDBACK

Gearbox Duty Cycle Selection: S2/S4/S6 Ratings and What They Mean for Gear Motors

Gear Motor Sizing for Mixers: Viscosity, Batch Cycle and Overload Margin

How to arrange the bearings in the reducer Selection: fixed end, moving end and axial clearance - Hangzhou Weigao Transmission

MEA Gearbox Market 2027: Water, Cement and the Orders That Come First

How to prepare spare parts for reducer maintenance: list of wearing parts, reserve quota and replacement principles - Hangzhou Weigao Transmission