Causes of oil leakage of planetary reducer

Publish Time: 2021-10-11     Origin: 威高传动

Planetary reducers are widely used in industrial production.But at the same time, some problems will be exposed, including oil leakage of planetary reducer, which is a common and troublesome problem for workers in all walks of life.Talk about the cause of the oil leakage of the planetary reducer.

1. The fuel tank pressure rises

In an enclosed planetary reducer, each pair of gears generates heat when meshing and rubbing.According to Boyle-Malote's law, as the running time prolongs, the temperature inside the reduction box will gradually increase, while the volume inside the reduction box remains unchanged, so the pressure inside the box will increase, and the lubricating oil in the box will decrease. Splash on the inner wall of the gear box.Due to the strong permeability of the oil, under the action of the pressure in the box, the oil will seep out of the place where the seal is not tight.

2. Oil leakage caused by unreasonable structural design of the reducer

If the designed reducer does not have a ventilation cover, the reducer cannot achieve pressure equalization, resulting in higher and higher pressure in the box and oil leakage from the planetary reducer.

3. Over fueling

During the operation of the reducer, the oil pool is violently stirred, and the lubricating oil splashes around in the reducer.If the amount of oil is too much, a large amount of lubricating oil will accumulate on the shaft seal, joint surface, etc., causing leakage.

4. Improper maintenance process

In the process of equipment maintenance, due to incomplete removal of dirt on the joint surface, improper selection of sealant, reverse installation of seals, untimely replacement of seals, etc., oil leakage will also occur.

The above is the reason for the oil leakage of the planetary reducer.In industrial production, oil spills are inevitable.What the vast number of industrial producers need to do is to pay attention at any time, pay attention at all times, avoid oil spill accidents as much as possible, and minimize industrial losses.


FEEDBACK

What are the common causes of failure of NGW102-6 planetary reducer bearing components?

What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?

How to judge whether there is a problem with the internal transmission pair of WP series reducer

What may be the causes of load fluctuations of WP series worm gear reducer?

Test the load before reducing the reducer Selection: on-site collection method of current, speed and load spectrum - Hangzhou Weigao Transmission