Analysis of Heating Possibility of Cycloidal Pinwheel Reducer

Publish Time: 2021-09-28     Origin: 威高传动

The cycloid reducer is an important part of the reducer.Generally speaking, there may be failure factors in the reduction gear.One of them is that the cycloid reducer device generates heat.What approach should we take to solve this problem?What might be the impact on the reducer if no measures are taken?
If it is found that the cycloid reducer has high overheating and temperature rise during use, it can be roughly divided into the following possibilities.
1. Cycloidal pinwheel reducer bearings are cheap, which is an influencing factor and abnormal situation.
2. The above is a common possibility.It may also be that the cycloid reducer is relatively new, and there are some problems during assembly.In the face of these situations, after the equipment temperature of the cycloid reducer is abnormal, we need to have such an idea in our mind based on past experience, but we also need to distinguish it according to the actual situation.
3. Compared with the overheating of the cycloid reducer, such factors also need to be considered, including whether there is any abnormality in the lubrication and whether the lubricating oil is insufficient, which may cause various abnormalities.Analyze one by one and review carefully.
4. Of course, there are some factors to consider.If the cycloid reducer is overloaded, it may also cause the temperature to rise.
For the above reasons, we need continuous analysis and research to find out the final answer step by step.If the temperature of the cycloid reducer is relatively high, it will test our mastery of some knowledge points of the reducer, including theoretical factors and practical factors.
According to the above steps, through past experience, data analysis and voice identification, it is not difficult to find the problem.

FEEDBACK

What are the common causes of failure of NGW102-6 planetary reducer bearing components?

What are the repair methods after the NGW81-25 planetary reducer bearing assembly fails?

How to judge whether there is a problem with the internal transmission pair of WP series reducer

What may be the causes of load fluctuations of WP series worm gear reducer?

Test the load before reducing the reducer Selection: on-site collection method of current, speed and load spectrum - Hangzhou Weigao Transmission