Worm gear reducer gear damage case analysis

Publish Time: 2021-11-30     Origin: WGT

The worm gear reducer is the main equipment of the binding machine.In order to better promote the smooth operation of the extruder worm gear reducer, we need to attach great importance to the maintenance of the spline shaft teeth in the connection of the transmission system.However, judging from the current situation, the spline shaft teeth of the low-speed shaft of the worm gear reducer are prone to wear during operation, which not only endangers the traditional production and manufacturing, but also speeds up the service life of the worm gear reducer.According to this, in the following content, the wear condition of the spline shaft teeth of the low-speed shaft of the worm gear reducer will be deeply analyzed through specific examples, which is expected to provide important practical value for relevant personnel.
To be blunt, the essence of a worm gear reducer is an organization with a driving force, mainly including motors, gas turbines and other high-speed power systems.According to the power system on the worm gear reducer, the speed of operating equipment can be reduced.Usually, during operation, the output power of the worm gear reducer must be pre-configured in the production process.In the case of insignificant and super large, the output power is usually not easy to change.In this case, if the speed increases, the torque will continue to decrease; if the speed decreases, the corresponding thrust will increase.Depending on the specific situation, it was found that some manufacturing companies intend to increase the torque in order to better achieve the goal of mass production, relying on the worm gear reducer to promote the effect of increasing the operating speed of the motor.
The reasons for the gear wear of the worm gear reducer can be solved from the following aspects.First of all, the spline shaft teeth have not been fully maintained for a long time, and less oil problems cause the wear problem of the gear of the worm gear reducer; secondly, if a trace of metal material fragments are added to the grease during the daily operation of the gear of the worm gear reducer, It will also be the direct cause of the wear problem; three, in the manufacturing process of some worm gear reducers, due to the lack of effective manufacturing raw materials, there will be wear problems in the production process.In addition, for worm gear reducers, if the gear engagement and fit accuracy of the worm gear reducer is not strictly managed, it will also cause wear problems.
In order to better deal with the gear wear problem of the worm gear reducer, the key is to take the following preventive measures.Worm gear reducer 1, promotes the continuous improvement of the strength of the gear surface layer of the worm gear reducer, promotes the gear surface layer of the worm gear reducer to be smooth, smooth, and reduces wear conditions; the worm gear reducer II can promote grease during the operation of the worm gear reducer gear Cleaning and cleaning of its equipment and can start during the operation of the gear of the worm gear reducer, and it is also possible to add anti-wear chemicals to the grease.This magnetic substance can be used to absorb alloy chemicals in the grease, as long as the chemical substance of the metal material in the lubricating oil grease is continuously reduced, it is an important measure to prevent gear wear of the worm gear reducer.

FEEDBACK

Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand

How to check the carrying capacity of worm gear reducer: working condition coefficient, efficiency and Selection calculation example - Hangzhou Weigao Transmission

Lubrication and maintenance characteristics of B series industrial gearboxes

What are the common misunderstandings in B series gearbox maintenance?

Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor