What kind of noise will the reducer produce if the box manufacturing accuracy is not up to standard?
Publish Time: 2026-11-12 Origin: Site
1. Mesh impact noise caused by shafting hole position deviation
Periodic knocking sound due to gear eccentric load: When the parallelism and coaxiality deviation of the box bearing hole exceeds 0.01mm, the shaft system will be deflected after installation, the gear tooth width direction will be unevenly contacted, one end will be overloaded, and a rhythmic "click" knocking sound will be produced synchronously with the rotation speed. The noise is light when no load is loaded, and is obviously intensified after being loaded.
Exclusive whistling sound of worm gear: The hole position of the box of the worm gear model is out of tolerance, which will cause the center distance between the worm and the worm gear to deviate, the meshing backlash to be out of control, the tooth surface to be forcibly scraped during operation, and a sharp metal whistling sound will be emitted, accompanied by a rapid local temperature rise.
Planet carrier eccentric impact sound: The position of the planet shaft hole in the planetary reducer case is not up to standard, the planet carrier is eccentric when rotating, and the planet gear periodically collides with the internal ring gear when meshing, resulting in a low-frequency "clack" impact sound.
2. Abnormal friction noise caused by failure of bearing matching accuracy
The bearing outer ring crawls and makes a dull rumbling sound: The processing of the box bearing seat hole is extremely poor, and the fit between the bearing outer ring and the hole is too loose. The outer ring crawls once every time the bearing rotates, making a low rumbling sound, accompanied by obvious radial vibration.
Abnormal rustling sound of bearing clearance: The deviation of the box hole shape and position causes the clearance to be out of control after the bearing is installed. If the clearance is too small, the rolling elements and the raceway will be forced to squeeze and rub. If the clearance is too large, the rolling elements will move. In both cases, a continuous grainy "rustling" friction sound will be produced.
Early bearing damage and high-frequency screeching sound: The coaxiality of the box hole is seriously out of tolerance, the inner and outer rings of the bearing are deflected, the raceway is partially stressed and overloaded, pitting and spalling occur in a short period of time, and high-frequency metal squealing sounds are emitted during operation.
3. Resonance radiation noise caused by insufficient cabinet rigidity
Full-band amplified buzzing resonance sound: The box wall thickness is uneven, the reinforcement rib layout is missing or insufficient, the rigidity is greatly reduced, the vibration generated by the internal gear meshing and bearing rotation radiates outward through the box wall, and the originally normal transmission sound is amplified into a continuous low-frequency "buzzing" roar.
Resonance whistling in a specific speed range: When the natural frequency of the box is close to the gear meshing frequency, a noise peak will suddenly appear at a certain fixed speed, and the noise will immediately weaken significantly when leaving this speed range. This is a typical structural resonance whistling.
Thin-wall flutter noise of the cabinet: The large thin-walled area of the cabinet has no reinforcement ribs. During operation, it is driven by the internal excitation force to produce micro-amplitude flutter. The transmission noise is superimposed to form a diffuse broadband buzz. The radiation noise of the whole machine is 5~10dB(A) higher than that of the qualified cabinet.
4. Secondary noise derived from cabinet shape and position deviation
Seal wear and hissing sound: The verticality of the output shaft hole of the box is out of tolerance, and radial deflection occurs when the shaft rotates. Periodic eccentric wear occurs between the lip of the skeleton oil seal and the shaft surface, and a subtle "sizzling" friction sound continues. Long-term operation may also cause oil leakage.
Dislocation and impact sound of the joint surface: The flatness of the upper and lower joint surfaces of the box is not up to standard, and the box is misaligned and deformed after closing. There is slight interference in the internal transmission components, and irregular intermittent impact sounds are generated during operation.