What is the function of the breathable cap of the ZD80-5-2 soft tooth surface gear reducer?

Publish Time: 2026-11-10     Origin: Site

1. Core pressure balance

When the equipment is running, the gears and bearings generate friction and heat. The air and oil mist in the box are heated and expand. The breathable cap can discharge the hot air in time to maintain the same internal and external pressure.

Avoid the formation of positive pressure in the box, prevent lubricating oil from being squeezed out by high pressure from the oil seal, box joint surface, oil sight window, etc., and reduce oil leakage from the root cause.

When negative pressure forms in the box after shutdown for cooling, the breathable cap can prevent external air with impurities from being forcibly sucked into the box through the sealing gap.

2. Protection against impurities and moisture

The internal filter or labyrinth structure can intercept external dust and particles from entering the box and prevent impurities from contaminating the lubricating oil.

Some breathable caps with filter layers can reduce water vapor intrusion, reduce the risk of gear and bearing corrosion, and protect internal transmission components.

Prevent impurities from blocking the air passage or entering the meshing surface to cause abrasive wear, thereby extending the service life of the soft tooth surface gear.

3. Auxiliary heat dissipation and working condition adaptation

Continuously discharge the hot air in the box to promote heat convection, assist in lowering the oil temperature, and prevent excessive oil temperature from accelerating the aging of the oil seal and premature oxidation of the lubricating oil.

It is suitable for medium-speed and heavy-load conditions of small and medium-sized soft tooth surface reducers such as ZD80, and can maintain stable cavity pressure without the need for additional complex pressure relief devices.

Reduce the risk of abnormal heating caused by pressure imbalance and prevent the oil temperature from rapidly rising above 85°C after the equipment is loaded.

4. Key points of daily maintenance

It must be installed at the highest position of the box, facing up vertically. It is strictly prohibited to tilt or face down to prevent oil from directly splashing out and blocking the channel.

It is recommended to check the smoothness once a month. In dusty working conditions, the inspection frequency needs to be increased. After blockage, use compressed air to blow out the filter sludge from the inside out.

When cleaning is ineffective or the filter is damaged, it must be replaced immediately. It is prohibited to directly drill holes in the box to replace the breathable cap, otherwise the lubricating oil will be quickly contaminated.

FEEDBACK

Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand

How to check the carrying capacity of worm gear reducer: working condition coefficient, efficiency and Selection calculation example - Hangzhou Weigao Transmission

Lubrication and maintenance characteristics of B series industrial gearboxes

What are the common misunderstandings in B series gearbox maintenance?

Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor