What are the reasons for abnormal noise in the gearbox during the trial operation of ZQ400-48.57 reducer?

Publish Time: 2026-11-17     Origin: Site

1. Abnormal meshing of gear system

There were residual burrs and bumps in the gear tooth surface processing, which directly caused metal scraping and abnormal noise in the early stage of trial operation.

The tooth side clearance was not calibrated during assembly and exceeded the standard range of 0.12~0.15mm for this model, resulting in impact sounds from the meshing.

The axial positioning of the gear fails, axial movement occurs, and the tooth surface edges are in partial contact, causing periodic abnormal noise.

The center distance of the gear pair is assembled incorrectly, causing the meshing marks to be skewed and causing low-frequency buzzing during operation.

2. Abnormal bearing assembly and status

The clearance is not adjusted when the new bearing is installed. If it is too large, it will cause abnormal noise, and if it is too small, it will cause a dull friction sound.

The bearing raceways and rolling elements have factory anti-rust grease residue or slight bumps, and they make rustling sounds during trial operation.

The preload force of the tapered roller bearing is improperly set, and uneven friction resistance causes intermittent abnormal noise during operation.

The inner and outer rings of the bearing are too loosely matched with the shaft and box holes, causing circling, accompanied by low-frequency rumble.

3. Lubrication system adaptation issues

The oil level was filled incorrectly before the trial run. It was lower than 1/3 of the oil window, resulting in local dry friction of the gears and bearings.

The viscosity of the lubricating oil Selection is too low and cannot form an effective pressure-bearing oil film on the surface of the soft tooth surface gear.

Impurities such as molding sand and metal chips remain inside the box, which are mixed with oil and scratch the tooth surface to produce abnormal noise.

The assembly of the lubricating oil return tank is misaligned, and some meshing parts cannot receive sufficient oil supply, causing local friction sounds.

4. Assembly accuracy deviation of the whole machine

The alignment of the couplings between the input shaft and the motor, and the output shaft and the working machine exceeds the standard, causing periodic vibration and abnormal noise.

When closing the boxes, the box positioning pins were not installed and the bolts on the joint surfaces were tightened in the wrong order, resulting in misalignment of the shafting holes.

The anchor bolts were not tightened step by step according to the specified torque, causing slight displacement of the machine body during operation, causing resonance and abnormal noise.

The assembly of the input shaft end cover and bearing gland is skewed, interfering with the operation of the shaft and producing irregular friction sounds.

5. Problems with cabinet and accessory parts

The box was slightly impacted and deformed during transportation, the parallelism of the shaft system was extremely poor, and the gear meshing was unbalanced and made abnormal noise.

Anti-rust paint flakes and welding slag remaining on the inner wall of the box fall off, and get stuck in the tooth gaps after operation, causing impact sounds.

The breathing valve was not opened at the factory, and the pressure inside the box increased rapidly with the temperature rise during the trial operation, destroying the lubrication state and causing abnormal noise.

The locking disk and connecting key on the output shaft are not locked, and there is relative sliding during transmission, resulting in a clicking sound.

FEEDBACK

Offshore Wind Vessel Gearbox Market 2027: Crane and Winch Drive Demand

How to check the carrying capacity of worm gear reducer: working condition coefficient, efficiency and Selection calculation example - Hangzhou Weigao Transmission

Lubrication and maintenance characteristics of B series industrial gearboxes

What are the common misunderstandings in B series gearbox maintenance?

Apron Feeder Gearbox Selection: Chain Pull, Shock Load and Service Factor