The use and precautions of worm gear reducer
Publish Time: 2021-11-10 Origin: WGT
Operation of worm reducers: should worm reducers do any work before use?
Unit shafts should be cleaned prior to operation.Check the device shaft for bruises and dirt.If so, delete them completely.The working temperature of the reducer is 0~40℃.Check whether the cooperation scale of the hole (or shaft) connected with the reducer meets the requirements.The service of the hole shall be H7 (the service of the shaft shall be H6).Before operation, replace the blockage at the highest position with an exhaust plug to ensure that the gas in the body is exhausted during the operation of the reducer.
The use and precautions of worm gear reducer?
The worm gear reducer should be installed on a flat and solid base, the anchor bolts must be fixed, and the reducer housing must not be knocked by gravity to avoid damage.
Precautions for worm gear reducers include the following points.
1. Regularly check whether the installation foundation, seal and transmission shaft are normal.
2. Try to select the original accessories and replace them in pairs.When assembling the output shaft, pay attention to the forgiving fit.
3. If in normal use, the maximum temperature of the lubricating oil should be less than 85°C.In case of abnormal oil temperature rise and abnormal noise, stop the machine immediately for inspection.After troubleshooting, the main can continue to use.