Reduce instability of servo motor reducer
Publish Time: 2021-09-04 Origin: 威豪传播
As servo motor reducer drives become more common in industry, they are being used in a wider range of applications.A common complaint with servo motor reducers is that they sometimes produce an unwanted 'growling' noise.This problem can be eliminated by reducing the gain on the speed controller.However, lower speed controller gains may result in increased position error and reduced required performance.This article describes the problem of servo instability and methods that can be used to eliminate this problem.It's best to define unstable first.Instabilities in electric motors are uncontrolled and unexpected movements on the motor shaft.It can occur at low or high frequencies, with higher frequencies usually becoming audible (ie growling).The instability is caused by excessive gain of the drive's speed controller.The gain setting of the speed controller determines how much torque the drive will produce.Therefore, the gain value should be proportional to the inertia of the connected load seen by the motor shaft.Remember the 'sentence' phrase that 'motor shaft sees, as we'll examine later in this article what that means and how it affects stability. Some may wonder why they never have a stable Question. It should be clear that vector drives can also reach unstable conditions. In practice, most servo applications are more dynamic than speed-only applications. The more dynamic the application, the higher the gain required from the speed controller, thus Increases the likelihood of instability. Several factors can contribute to the likelihood of experiencing an unstable drive. These include:
Excessive Gain of Servo Motor Reducer Speed Controller
A resolution feedback device (i.e. resolver or pulse encoder) under the servomotor reducer on the motor
Servo motors replicate speed and mechanically 'decouple' the load from the motor