How to prevent rust of reducer

Cycloid pin gear reducer is a novel transmission device which applies the principle of planetary transmission and adopts cycloid pin tooth meshing. All transmission devices of cycloidal pinwheel reducer can be divided into three parts: input part, deceleration part and output part. Reducer is an independent component composed of gear transmission, worm transmission and gear worm transmission enclosed in a rigid shell. It is often used as a reducer between the prime mover and the working machine. Generally speaking, the rust of the reducer is caused by the presence of oxygen and moisture in the lubricating oil, and the so-called corrosion condition is caused by the acidic components and sulfide substances in the reducer oil, In this way, some rust prevention components can be added to the oil of the reducer, so as to complete the maintenance of the reducer. The antirust layer of the reducer is volatile combustible gas. Open fire is strictly prohibited when opening the sight glass cover. The output and input shaft ends are coated with anti rust layers respectively. The reducer must be stored in a covered place. It needs to be protected from rain, sun, frost and moisture. It cannot be exposed to the open air. Otherwise, it is easy to produce condensate inside the reducer, causing the reducer to rust. Use such methods as hot plating or electroplating to add oxide film or protective layer on the outside of the reducer, so as to prevent rust caused by water and gas of the reducer device, including such substances.