During regular maintenance, what aspects should be paid attention to when checking the lubrication system of the QJR-D236-1 gear reducer?
Publish Time: 2026-11-10 Origin: Site
1. Oil level compliance inspection
Stop the engine and cool down for 10 to 15 minutes. After the oil has completely returned, use the oil dipstick/dipstick to confirm that the oil level is between the upper and lower scale lines.
Under oil bath lubrication conditions, it is necessary to ensure that 1/3~1/2 of the tooth height of the final gear is immersed in the oil surface to avoid insufficient oil immersion or overheating of the churned oil.
It is forbidden for the oil level to be lower than the lower limit, causing dry friction, and not to be higher than the upper limit, causing abnormal rise in oil temperature and oil seal leakage.
2. Lubricating oil quality inspection
Visually inspect the oil status: Normal oil is uniformly light yellow/amber in color, with no blackening, emulsification, whitening, or layered precipitation.
Filter paper drop sample test: There are no obvious metal debris or sand in the center of the oil spot, and there is no grainy and astringent feeling when rubbed with your fingers.
Abnormality determination: black oil with a burnt smell indicates oxidative deterioration, milky white turbidity indicates water emulsification, and metal particles indicate gear/bearing wear.
It is strictly prohibited to directly mix lubricating oils of different brands and grades to avoid chemical reactions in the oils.
3. Seal and anti-leakage inspection
Full coverage inspection of shaft end oil seal, flange joint surface, oil level gauge interface, oil drain plug, oil filling port and other parts.
Slight oil leakage can be eliminated by tightening the bolts diagonally. If oil drips or the oil level drops sharply, the sealing failure will be determined, and the aging oil seal or gasket needs to be replaced in time.
Simultaneously check that the breathable plug is unobstructed and unobstructed to prevent oil leakage and oil vapor spurting caused by excessive pressure in the tank.
4. Inspection of oil circuit and auxiliary components
Oil bath lubrication model: Check that there is no metal precipitation or debris blocking the oil guide groove at the bottom of the oil pool to ensure that splashed oil can be smoothly introduced into the bearing chamber.
Forced lubrication model: Check the working status of the oil pump. The oil pressure is stable within the rated range of 0.1~0.3MPa, and the oil pipe is not broken, loose, or blocked.
Check the filter pressure difference indicator. If a red alarm appears or the filter element is filled with particles, clean or replace the filter element immediately.
If a cooler is configured, it must be confirmed that there is no leakage or fin blockage to ensure that the oil temperature is controlled within a reasonable range.
5. Dynamic verification of operating conditions
Start idling with no load for 3 to 5 minutes and then load gradually. There is only a uniform and slight buzzing during operation, and no abnormal noise caused by metal dry friction.
Use an infrared thermometer to monitor the oil temperature. Under rated load, the lubricating oil temperature is ≤90°C. There is no local overheating of the bearing seat and the temperature difference between the bearing seat and the shell is ≤10°C.
Use a vibration meter to detect the vibration intensity, which complies with the ISO 10816 standard. There is no sudden increase in meshing frequency harmonics caused by poor lubrication.
Establish an exclusive maintenance ledger to record each oil quality test, oil change, and component replacement parameters to achieve full-cycle status traceability.