Correction installation steps of cycloid gear in cycloid pin reducer

The reducer industry is of great significance to many industries, and the controller roller reducer, as a kind of reducer, also plays a great role.Care should be taken to install cycloidal gears in cycloidal pin reducers, but no mistakes will be made.Let us introduce the correct installation steps of the cycloidal gear in the cycloidal pin reducer:
First, check if the two looped wheels are a pair.The manufacture of the ring wheel is based on the pair, that is, the two pieces of the ring wheel are not separated during the production process.When installing, the concept of a pair is that the two cycloidal wheels can completely coincide.Including bearing holes, ten holes (shaft pin holes) and external gear profiles for safe coincidence at the same time.From the front, it's one piece.If they can overlap, it proves that they are a pair, and if they cannot overlap, it proves that they are not a pair and cannot be used.Note that there are positive and negative ring wheels.There are symbols on the circular wheels, and each pair of circular wheels has different symbols.
The second step is to rotate a belt air-conditioning wheel by 180°, that is, when the central bearing hole is completely coincident, the outer tooth profile is just lagging, and the tooth heel orientation of the upper piece is only the tooth top orientation of the lower piece.Note that the relative orientation of the two wheels must be remembered.Draw the symbols yourself or memorize the orientation of the original symbols on the wheel.(This is a cycloidal wheel with a single tooth difference, the double tooth difference does not need 180°).
The third step is to put a cycloidal wheel into the pin tooth case, and first roll it by hand to see if it flows and swings.
Step 4 Put in the offset bearing.Because the bearing hole of the cycloidal roller is equivalent to the outer sleeve of the offset bearing, the correct orientation of the offset bearing is that the bearing hole of the lower cycloidal wheel just completely contains the cylindrical ball of the offset bearing.Step 5 puts in the distance ring.The sixth step is to put another cycloid wheel, which is the key.Directions should be based entirely on the symbols you draw.Step 7 Put it on the shaft sleeve and roll it by hand to see if it can roll and the device is correct.
After reading the above introduction, we know a lot about the correct installation steps of the cycloidal gear in the cycloidal pin reducer, so we can't go wrong.