BLD3-23 7.5KW cycloidal pinwheel reducer output shaft accuracy and roughness specifications
Publish Time: 2026-10-10 Origin: Site
The journal that matches the inner ring of the P0-level rolling bearing usually uses k6 (such as Φ55k6, Φ56k6), and adopts tolerance requirements; the journal that matches the gear is selected as r6 (interference) or n7 according to torque and accuracy; the output shaft end and the coupling are usually H7/k6 or H7/h6, and the specific tolerance zone is determined according to the product technical document or GB/T 1095-2003.
The journal diameter tolerance level is generally IT5~IT7. The journals that play a supporting role require higher precision (IT5~IT7), and the journals that assemble transmission parts require relatively lower precision (IT6~IT9).
The tolerance zone of the keyway width on the shaft is usually N9; the unspecified dimensional tolerance is generally implemented according to the medium level of GB/T 1804-m.
2. Geometric tolerance
The cylindricity of the journal that matches the inner ring of the bearing is usually 0.005mm (level 6); the radial circular runout of the journal where the bearing is installed relative to the public datum AB is usually 0.025mm (level 7); the circular runout of the shoulder positioning end face is usually 0.015mm (level 6); the symmetry of the keyway is generally level 7 to 9.
The shape accuracy such as straightness and roundness is generally controlled within 0.01mm, the axial/radial runout of the universal transmission shaft is controlled within 0.02mm, and the radial runout of the high-speed output shaft should be controlled within 0.01mm.
3. Surface roughness
The upper limit Ra of the journal that cooperates with the bearing and gear is usually 0.8 μm; the upper limit Ra of the shoulder positioning end face is 3.2 μm or 1.6 μm (depending on the specific end face); the upper limit Ra of the sealing contact surface is 1.6 μm.
More stringent occasions: the support journal Ra that matches the bearing is less than 0.8μm, and can be 0.63~0.16μm under high precision requirements; the shaft diameter Ra that matches the transmission part is 2.5~0.63μm.
Maintenance standards usually also require that the output shaft and rolling bearing must have a surface roughness of Ra0.8 and a matching tolerance of H7/k6, and the shaft and journal must not have cracks, burrs, or scratches.
4. Process tips
The grinding process is generally arranged after secondary surface processing such as splines, keyways, threads, etc., and after quenching treatment; the center holes at both ends are preferred for the positioning reference. Keyways, grooves, etc. should be completed after semi-finishing and before finishing to avoid bending deformation caused by large cutting forces after finishing.