Advantages of using cycloid reducer
Publish Time: 2021-10-15 Origin: Site
Cycloidal pinwheel reducer is a kind of machine that realizes deceleration through cycloidal pinwheel meshing according to the principle of small tooth difference of planetary transmission.This machine is divided into vertical, horizontal, double-axis and direct-coupled.It is the equipment for mining, construction, metallurgy, textile, chemical industry, light industry and other industries.Compared with the vertical reducer and other reducers of the reducer factory, the cycloid reducer has the following advantages:
Cycloidal pinwheel reducer has the following characteristics:
1. Large transmission ratio: single-stage transmission ratio 9-87, double-stage transmission ratio 99-7569, multi-stage series transmission ratio can be larger;
2. High transmission efficiency: single-stage transmission efficiency is over 90%;
3. Compact structure: small size, light weight, high-speed shaft and low-speed shaft on the same axis, easy to disassemble;
4. Stable operation, low noise, able to withstand overload and impact;
Compact structure, small size and light weight.
The cycloidal pinwheel reducer has a high speed ratio, the transmission ratio of the first deceleration is 1:7~1:87; the speed ratio of the second deceleration is 1:121~7569, etc.
Due to the rolling engagement of the meshing part of the tooth surface of the cycloid reducer, there is no relative sliding on the meshing surface, the general efficiency is above 90%, and the transmission efficiency is high.
Due to the reasonable structural design and few parts, the cycloidal pinwheel reducer has the advantages of convenient disassembly, convenient maintenance, and simple lubrication.
The principle of planetary transmission is adopted.During operation, the teeth of the swing needle are large, and the overlapping coefficient is large.The entire fuselage runs in balance.The main parts are made of bearing steel after quenching, and the wear is reduced to a low level.Therefore, the service life is long and the noise generated during operation is low.